Configuring security settings using the CLI wizard
To configure the security settings using the CLI wizard, follow the steps below:
Procedure
At the command prompt, enter
setup mgmt-interfaces.
The welcome banner appears and the first setup option is displayed (operator password). As you advance through the wizard, each setup option displays the current value in brackets
[].
Management Interface wizard configuration
When you enter the wizard, you have the following options:
To update a setting, type in a new value, or press
Enter to keep the current value.
To quit the wizard without saving any changes, press
CTRL-C at any time.
To access online Help for any option, press
?.
After you have gone through each setup option, the wizard displays the summary configuration together with a prompt to save the changes.
When the message appears asking if you want to save these changes, you have the following options:
To save your changes, press
Enter.
To cancel any changes without saving, enter
n and then press
Enter.
After pressing
Enter, the wizard exits to the command line prompt.