Using a Member’s CLI to make the Member Commander of a new stack
This procedure requires that you first remove the Member from its current stack, then create the new stack.
NOTE:
If you do not know the MAC address for the Commander of the current stack, use
show stack
to list it.
Syntax:
no stack join <MAC address>
stack commander <stack name>
Suppose a switch named
Bering Sea
is a Member of a stack named
Big_Waters
. To use the CLI to convert it from stack Member to Commander of a new stack named "Lakes", use the above commands as shown in the following example.
Using a member's CLI to convert the member to the commander of a new stack
