Configuring per-port Forced Fast-Leave IGMP

In the factory-default configuration, Forced Fast-Leave is disabled for all ports on the switch. To enable (or disable) this feature on individual ports, use the switch setmib command.

Configuring Per-Port Forced Fast-Leave IGMP on Ports. This procedure enables or disables Forced Fast-Leave on ports in a given VLAN. 

switch(config)# setmib hpswitchigmpportforcedleavestate.1.6 -i 1
hpSwitchIgmpPortForcedLeaveState.1.6 = 2
where 1 in .1.6 is the default VLAN, 6 in .1.6 indicates port 6 and = 2 verifies Forced Fast-Leave disabled.

Syntax:

setmib hpSwitchIgmpPortForcedLeaveState.< vlan number >< .port number >-i < 1 | 2 >

OR

setmib 1.3.6.1.4.1.11.2.14.11.5.1.7.1.15.3.1.5.< vlan number >< .port number > -i < 1 | 2 >

where:

Forced Fast-Leave values

1

Enabled

2

Disabled

For example, suppose that your switch has six ports as members of the default VLAN. To enable Forced Fast-Leave on port 6, you would execute the following command to obtain the result.

Changing the Forced Fast-Leave Configuration on Port 6.

switch(config)# setmib hpswitchigmpportforcedleavestate.1.6 -i 1
hpSwitchIgmpPortForcedLeaveState.1.6 = 1

where 1 in .1.6 is the default VLAN, 6 in .1.6 indicates port 6 and = 1 verifies Forced Fast-Leave enabled.