Configuring Smart Link

Use the following commands to configure Smart link:

• Create a smart link group, using optional parameters as necessary:

  
  switch(config)# no smart-link group group-id
  

  Options

  
  master port
  

  
  slave port
  

  
  protected-vlans vid-list
  

  
  send-control-vlan vid
  

  
  preemption-mode {off | forced | bandwidth}
  

  
  preemption-delay 10...max
  

  
  trap {enable | disable}
  

  NOTE:

  When executed without any parameters, this command enters into Smart link group context.

• Configure VLANs to receive flush messages. This is an interface level command. It must be executed for both the master and the slave port.

  
  switch(config)# smart-link recv-control-vlan vid-list
  

• Enable debug messages for a Smart link group:

  
  switch(config)#debug smart-link [group group-id | all] [flush-packets]