Optional - Users should update to this version if their system is affected by one of the documented fixes or if there is a desire to utilize any of the enhanced functionality provided by this version.
Problems Fixed:Resolved an issue where a non printable character was present in the memory serial number in SMBIOS type 17.
Resolved an issue where erroneous fan and power supply failure status was reported during POST after updating the Power Management Controller firmware on the SL6000/6500.
Resolved an issue where the "rbsureset" command in the SmartStart Scripting Toolkit Utility does not restore the system configuration to the default settings.
Resolved an issue where the system automatically PXE boots from embedded NIC port 1 whenever CMOS is cleared.
Resolved an issue where the HP E200 Option ROM configuration screen does not redirect to Remote Console.
Resolved an issue where the 'QPI_Frequency', 'Memory_Frequency', 'Restore_on_AC_Power_Loss' and 'Advanced_Memory_Protection' options cannot be modified by the CONREP utility.
Resolved an issue where the hard disk cannot be detected whenever the 'SATA#1 Controller' Mode is set as 'RAID' and 'BIOS Serial Console' is set as 'Enabled'.
Resolved an issue where the system will occassionally hang early in POST with the fans at max speed with the 12LFF hard disk backplane installed.
Updated the identification string from "Left-Top / Tray 2 Node 1" to "Tray 2 Node 1" in the SMBIOS table type 2 for the SL160z G6.
Updated the memory device type to DDR3 in the the SMBIOS table type 17.
Updated the B110i software RAID firmware to version 1.38 to address an issue where the system would not boot to USB floppy when the Embedded SATA RAID was enabled.