Recommended - HP recommends users update to this version at their earliest convenience.
This firmware has been tested and released only for the platforms listed below. This firmware should not be flashed onto any other systems.
HP ProLiant DL170h G6 - O34
HP ProLiant DL2x170h G6 - O34
HP ProLiant DL4x170h G6 - O34
HP ProLiant SL160z G6 - O33
HP ProLiant SL170z G6 - O34
HP ProLiant SL2x170z G6 - O34
HP ProLiant DL160 G6 - O33
HP ProLiant DL180 G6 - O20
HP ProLiant DL160se G6 - O20
HP ProLiant DL165 G7 - O37
HP ProLiant SL165z G7 - O37
Programming the LO100 firmware may take up to fifteen minutes or more to complete on some servers with some operating systems. Do NOT interrupt this programming process! A reboot followed by the BIOS flashing SDRs is no longer required for this online flash component.
Note that online firmware flashing on Microsoft Windows Server 2003 is NOT supported.
Resolved an issue that always caused a redundancy lost message at bootup on systems that supported redundant power supplies or fans but did not have redundant power supplies or fans installed.
Resolved an issue with DCMI compliance by no longer indicating power management capable on hardware without power management capabilities.
Resolved an issue with the advanced license demo keys correctly displaying the days remaining when close to expiration.
Resolved a rare factory flash issue that could result in corrupting the BMC firmware during the flash. This issue has only been observed in rare circumstances during the manufacturing process.
Resolved an issue with systems capable of supporting redundant fans or power supplies, which could result in a web summary page health indication or IPMI chassis status indicating a failure when a redundant fan or power supply is not installed.
Resolved a web interface issue where the MAC address was not being accepted correctly in the PEF configuration webpage.
Resolved a problem where the -h and -x options at the end of a CLP Load command were not processed.
Resolved a remote graphical console issue for a text mode used in Solaris 9 that would cause formatting problems.
Resolved a remote graphical console issue for Red Hat 5 for an unsupported graphics mode that prevented viewing the remote OS boot process.
Resolved an issue that prevented the remote graphical console feature from starting when using SSL.