Print | Rate this content

HP ProCurve Switch - Reset to factory defaults on ProCurve Switch 1810G series

AskProCurve Article

Title:

HP ProCurve Switch - Reset to factory defaults on ProCurve Switch 1810G series

Available Part Numbers:

J9449A HP ProCurve 1810G-8 Switch,J9450A HP ProCurve 1810G-24 Switch

Issue Description:

How do I reset factory defaults on the ProCurve Switch 1810G series?

Solution:

When the “Clear” button is pressed with the “Reset” button, any configuration changes you may have made through the switch console, the web browser interface, and SNMP management are removed, and the factory default configuration is restored to the switch.

Specific steps to execute the factory default reset on the switch are:

1. Using a small, thin tool with blunt ends (such as a paper clip), simultaneously press both the Reset and Clear buttons on the front of the switch.

2. Continue to press the Clear button while releasing the Reset button.

3. When all three Mode LEDs (Act, FDx, and Spd) begin to blink, release the Clear button.

The switch will then complete its self test and begin operating with its configuration restored to the factory default settings.

Note: After completing this procedure, there will be no password, the IP address will be returned to the default 192.168.2.10, and all configuration settings will be returned to factory defaults.

Modified Date:

2009-12-06

Legal Disclaimer: Products sold prior to the November 1, 2015 separation of Hewlett-Packard Company into Hewlett Packard Enterprise Company and HP Inc. may have older product names and model numbers that differ from current models.

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!
Document title: HP ProCurve Switch - Reset to factory defaults on ProCurve Switch 1810G series
Document ID: emr_na-c02597119-1
How helpful was this document?
How can we improve this document?
Note: Only English language comments can be accepted at this time.
Please wait while we process your request.