Print | Rate this content

HP ProLiant ML110 G5 Server series - Overview

Product description

The HP ProLiant ML110 G5 server provides all the necessary server features in an affordable, functional package. The latest Intel processors, such as Intel Xeon and Pentium D processors, provide the necessary computing power, while a mix of PCI and PCI-Express slots delivers the expandability for the future that small businesses require. Also, the ML110 G5 can be upgraded with the cost-effective HP Lights-Out 100c Remote Management Card (RMC) for remote sites or second offices.

top

Product features

Standard Features
Description
Processor (One of the following depending on Model)
Quad-Core Intel Xeon 3220 (2.40 GHz, 1066 FSB,8 M)*
Quad-Core Intel Xeon 3210 (2.13 GHz, 1066 FSB,8 M)*
Dual-Core Intel Xeon 3075 (2.66 GHz, 1333 FSB, 4 M)*
Dual-Core Intel Xeon 3065 (2.33 GHz, 1333 FSB, 4 M)
Dual-Core Intel Core 2 E4400 (1.80 GHz, 800 FSB, 2 M)*
Dual-Core Intel Pentium E2160 (1.80 GHz, 800FSB, 1 M)
Single-Core Intel Celeron 440 (2.0 GHz, 800 FSB, 512 K)*
*Single-Core Intel Celeron 420 (1.6 GHz, 800 FSB, 512 K)*
NOTE: *Available through Configure To Order only. See Factory Integration Models section for more details.
Chipset
Intel 3200
Memory
Type
PC2-6400 unbuffered DDR2 ECC 800 MHz
Standard
512MB
1GB (SAS Models)
Maximum
8GB
Memory Protection
Unbuffered ECC
Expansion Slots
Slot Number
Bus Speed
Hot Plug Y/N
PCI Voltage
Notes
4
x8 PCI Express
No
n/a
Full height
2/3
X1 PCI Express
No
n/a
x8 Connector
Full height
1
32bit/33 MHz PCI
No
3.3 V
Full height
Technical Specifications
System Unit
Dimensions (HxWxD)
(with feet)
14.5 x 6.9 x 16.8 in (36.7 x 17.5 x 42.6 cm)
Weight (approximate)
Maximum
(all hard drives, power supplies, and processors installed)
39 lb (17.5 kg)
Minimum
(one hard drive, power supply, and processor installed)
23.81 lb (10.8 kg)
Input Requirements
(per power supply)
Rated Line Voltage
90 to 132 V ac,
180 to 264 V ac
Rated Input Current
6 A (at 100 V ac),
3 A (at 200 V ac)
Rated Input Frequency
47 to 63 Hz
Rated Input Power
600 W (at 100 V ac),
600 W (at 200 V ac)
Power Specifications
To review typical system power ratings use the Power Calculator. Click here to access HPE Power Advisor web page .
20 Calculator Catalog.xls
- Click on the system of interest. Example: DL380 G5
- Follow the instructions of the next screens.
Power Supply Output
(per power supply)
Rated Steady-State Power
365 W (at 100 V ac),
365 W (at 200 V ac)
Maximum Peak Power
385 W (at 100 V ac),
385 W (at 200 V ac)
System Inlet Temperature
Operating
10° to 35°C (50° to 95°F) at sea level with an altitude derating of 1.0°C per every 305 m (1.8°F per every 1000 ft) above sea level to a maximum of 3050 m (10,000 ft), no direct sustained sunlight. Maximum rate of change is 10°C/hr (18°F/hr). The upper limit may be limited by the type and number of options installed.
System performance may be reduced if operating with a fan fault or above 30°C (86°F).
Non-operating
-30° to 60°C (-22° to 140°F). Maximum rate of change is 20°C/hr (36°F/hr).
Relative Humidity
(non-condensing)
Operating
10% to 90% relative humidity (Rh), 28°C (82.4°F) maximum wet bulb temperature, non-condensing.
Non-operating
5% to 95% relative humidity (Rh), 38.7°C (101.7°F) maximum wet bulb temperature, non-condensing.
Altitude
Operating
3050 m (10,000 ft). This value may be limited by the type and number of options installed. Maximum allowable altitude change rate is 457 m/min (1500 ft/min).
Non-operating
9144 m (30,000 ft). Maximum allowable altitude change rate is 457 m/min (1500 ft/min).
HP 160GB 1.5G SATA 7.2K NHP 3.5" HDD411275-B21
160GB 7,200 rpm
Capacity
160,041MB
Height
1.0 in. (26.1 mm)
Width
4.0 in. (101.6 mm)
Interface
Serial ATA
Transfer rate synchronous (maximum)
1.5 Gb/s
Seek time (typical reads, including settling)
Single track
Average
Full-stroke
Rotational speed
Physical Configuration
Bytes/Sector
Logical Blocks
Operating Temperature
41° to 131° F (5° to 55° C)
NHP 72GB 3G SAS 15K 3.5" HDD431950-B21
72GB 15K
Capacity
73,407,856,856
Height
1.0 in (25.4mm)
Width
4.0 in. (101.6 mm)
Interface
SAS
Transfer rate synchronous (maximum)
3 Gb/sec
Seek time (typical reads, including settling)
Single track
Average
Full-stroke
Rotational speed
Physical Configuration
Bytes/Sector
Logical Blocks
Operating Temperature
50° to 95° F (10° to 35° C)
16X Max SATA DVD-ROM Drive
Disk
Applicable Disk
CD-ROM, CD-XA, CD-DA
(Mode 1, Mode 2, Form 1 and 2)
Photo CD (Single and Multi-session)
Mixed Mode (Audio and Data combined)
CD-R, CD-RW, DVD-ROM, DVD+R, DVD+RW
Capacity
4.7 GB (DVD-5)
8.54 GB (DVD-9)
Block Size
DVD Media
2,048bytes
Interface
SATA
Access Times (typical)
Random
<140 ms
Full-Stroke
<250 ms
Data Transfer Rate
Sustained
8100 to 21600 KB/s (6X to 16X)
Cache Buffer
128KB
Start-up Time (typical)
< 7 seconds
Stop Time
< 4 seconds
Laser Parameters
Type
Semiconductor Laser GaA1As
Wave Length
780 ± 25 nm
Operating Conditions
Temperature
41° to 122° F (5° to 50° C)
Humidity
10% to 90%
Dimensions
(HxWxD, maximum)
1.7 x 5.85 x 8.11 in (42.9 x 150 x 208 cm)
Weight
2.64 lb (1.2 kg)
HP 4 Internal Port SAS Host Bus Adapter (SAS/SATA HP Model)
SATA Protocol
SATA 1.5 Gb/s
SATA Ports
4 internal
Port transfer rate
1.5 Gb/s total
Maximum Storage Capacity
up to 3TB (4 x 750GB non hot plug SATA HDD)
Dimensions (excluding bracket)
6.6 x 2.5 x 0.6 in (16.8 x 6.4 x 1.6 cm)
Disk Drive and Enclosure Protocol Support
3 Gb/s SAS (Serial Attached SCSI)
1.5 Gb/s SATA (Serial Advanced Technology Attachment)
Architecture
64-bit
SAS Connectors
1 internal SFF8484 x4 Wide SAS Connectors
12 Gb/s per x4 Wide SAS Port (4 x 3 Gb/s)
Data Transfer Method
PCI-Express x8 - 2 GB/s maximum bandwidth
PCI Bus Speed
PCI-Express x8
Simultaneous Drive Transfer Ports
1 x4 Wide SAS Connectors
Port Transfer Rate
12 Gb/s per x4 Wide SAS Port (4 x 3 Gb/s)
Software upgradeable Firmware
Yes
Maximum Capacity
1.8TB (4 x 450GB)
Memory Addressing
64-bit, supporting servers memory greater than 4GB
Logical Drives Supported
Up to 2 Logical Volumes
Up to 10 drives total in all RAID volumes
Up to 2 Drives per RAID 1
Up to 4 Drives per RAID 0
RAID Support
RAID 1 (Mirroring)
OR
RAID 0 (Striping)
Upgradeable Firmware
4MB flashable ROM
Disk Drive and Enclosure Protocol Support
3 Gb/s SAS and 1.5 Gb/s SATA
HP E200/128 BBWC Smart Array Controller(Performance Model)
Dimensions (excluding bracket)
6.6 x 2.5 x 0.6 in (16.8 x 6.4 x 1.6 cm)
Disk Drive and Enclosure Protocol Support
3 Gb/s SAS (Serial Attached SCSI)
1.5 Gb/s SATA (Serial Advanced Technology Attachment)
Architecture
64-bit
SAS Connectors
2 internal SFF8484 x4 Wide SAS Connectors
12 Gb/s per x4 Wide SAS Port (4 x 3 Gb/s)
Data Transfer Method
PCI-Express x8 - 2 GB/s maximum bandwidth
PCI Bus Speed
PCI-Express x8
Simultaneous Drive Transfer Ports
2 x4 Wide SAS Connectors
Port Transfer Rate
12 Gb/s per x4 Wide SAS Port (4 x 3 Gb/s)
Software upgradeable Firmware
Yes
Maximum Capacity
3.6TB (8 x 450GB)
Memory Addressing
64-bit, supporting servers memory greater than 4GB
Logical Drives Supported
<FILL IN>
RAID Support
RAID 1 (Mirroring)
RAID 0 (Striping)
RAID 5
Upgradeable Firmware
4MB flashable ROM
Disk Drive and Enclosure Protocol Support
3 Gb/s SAS and 1.5 Gb/s SATA
Embedded NC105i PCIe Gigabit Server Adapter
Network Interface
Integrated 10/100/1000BASE-T Transceiver
Combines a triple-speed IEEE 802.3TM – Compliant Media Access Controller (MAC) with a triple-speed Ethernet transceiver.
Data Transfer Method
Compliant to x1 PCIe Specification
Network Transfer Rate
10Base-T (Half-Duplex)
10 Mb/s
10Base-T (Full-Duplex)
20 Mb/s
100Base-TX (Half-Duplex)
100 Mb/s
100Base-TX (Full-Duplex)
200 Mb/s
1000Base-TX (Half and Full-Duplex)
2000Mb/s
Connector
RJ-45 connector
Cable Support
Performs all the physical layer functions for 10BASE-T, 100BASE-T, and 1000BASE-T Ethernet on standard Category 5 UTP
Environment-friendly Products and Approach
End-of-life Management and Recycling
Hewlett-Packard Enterprise offers end-of-life HPE product return, trade-in, and recycling programs in many geographic areas. Click here to access Product Return and Recycling web page , or contact your nearest HP sales office. Products returned to HPE will be recycled, recovered or disposed of in a responsible manner.
The EU WEEE directive (2002/95/EC) requires manufacturers to provide treatment information for each product type for use by treatment facilities. Click here to access product disassembly instructions web page . These instructions may be used by recyclers and other WEEE treatment facilities as well as HPE OEM customers who integrate and re-sell HPE equipment.
OS Support
Microsoft Windows Server 2003 Web edition
Microsoft Windows Server 2003
Windows Server 2003 R2
Microsoft Windows Server 2008
Red Hat Enterprise Linux
SUSE Linux Enterprise Server
Netware

top

Links to QuickSpecs

Information for this Overview is taken from the product QuickSpecs. To access the complete QuickSpecs for this product, select the desired link from the following list:

top

Legal Disclaimer: Products sold prior to the November 1, 2015 separation of Hewlett-Packard Company into Hewlett Packard Enterprise Company and HP Inc. may have older product names and model numbers that differ from current models.

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!
Document title: HP ProLiant ML110 G5 Server series - Overview
Document ID: emr_na-c01271448-35
How helpful was this document?
How can we improve this document?
Note: Only English language comments can be accepted at this time.
Please wait while we process your request.