Listed are the declared A-Weighted sound power levels (LWAd) and declaredaverage bystander position A-Weighted sound pressure levels (LpAm) whenthe product is operating in a 23°C ambient environment. Noise emissionswere measured in accordance with ISO 7779 (ECMA 74) and declared inaccordance with ISO 9296 (ECMA 109).

Idle
L WAd	6.4 B
L pAm	49 dBA
Operating
L WAd	6.4 B
L pAm	49 dBA

All temperature ratings shown are for sea level. An altitude derating of 1C per 300 m (1.8F per 1,000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed.

Storage maximum humidity of 95% is based on a maximum temperature of 45C (113F). Altitude maximum for storage corresponds to a pressure minimum of 70 KPa.

top

Safety certifications

Specification	Description
Emissions Classification(EMC)
FCC rating	Class A
Normative standards	CISPR 22; EN55022; EN55024; FCC CFR 47,Pt 15; ICES-003; CNS13438; GB9254;K22;K24; EN 61000-3-2; EN 61000-3-3; EN60950-1; IEC 60950-1
NOTE: Product conformance to cited product specifications is based onsample (Type) testing, evaluation, or assessment. This product or family ofproducts is eligible to bear the appropriate compliance logos andstatements

top

Server specifications

Specification	Description
Dimensions
Height	4.32 cm (1.70 in)
Depth	69.22 cm (27.25 in)
Width	42.62 cm (16.78 in)
Weight (Maximum: two processors, two power supplies, six hard drives)	17.92 kg (39.50 lb)
Weight (Minimum: one processor, one power supply, no hard drives)	14.51 kg (32.00 lb)
Weight (No drives installed)	14.06 kg (31.00 lb)
Input requirement
Rated input voltage	100 V ac to 240 V ac
Rated input frequency	50 Hz to 60 Hz
Rated input current	7.1A (At 120 V ac); 3.5A (At 240 V ac)
Rated input power	852 W
BTUs per hour	2910 (At 120 V ac); 2870 (At 240 V ac)
Power supply output
Rated Steady-State power	Rated Steady-State power 700 W (At 100 V ac) 700 W (At 200 Vac) Maximum peak power 700 W (At 100 V ac) 700 W (At 200 V ac)

top

Hot-Plug power supply calculations

For hot-plug power supply specifications and calculators to determine electrical and heat loading for the server, refer to the HP Enterprise configurator website.

top

FBDIMM specifications

CAUTION: Be sure to install FBDIMMs in the proper configuration. Refer to the documentation CD.

Specification	Description
Type	FBDIMM, PC2-5300F, Fully-Buffered DIMMs
Size	512MB, 1GB, 2GB, 4GB, 8GB
Width	72 bits
Upgrade requirement	FBDIMMs must be installed in pairs within a bank. A bank must be populated with two FBDIMMs with identical HP part numbers.

Use only registered DDR2 FBDIMMs. Use HP FBDIMMs only.

top

1.44MB diskette drive specifications

Specification	Description
Dimensions
Height	12.7 mm (0.5 in)
Width	96 mm (3.8 in)
Depth	130 mm (5.1 in)
LEDs (front panel)	Green = On
Read/write capacity per diskette
High density	1.44 MB
Low density	720 KB
Drives supported	1
Drive height	One-Third height
Drive rotation	300 rpm
Transfer rate
High	500 Kb/s
Low	250 Kb/s
Bytes/sector	512
Sectors per track (high/low)	18/9
Tracks per side (high/low)	80/80
Access times
Track-to-track (high/low)	3 ms/6 ms
Average (high/low)	169 ms/94 ms
Setting time	15 ms
Latency average	100 ms
Cylinders (high/low)	80/80
Read/write heads	2

top

CD-ROM drive specifications

Specification	Description
Disk formats	CD-ROM (Modes 1 and 2); mixed mode (Audio and data combined); CD-DA; Photo CD (Single/multiple-Session), CD-XA ready; CDi ready
Capacity	550 MB (Mode 1, 12 cm)
Capacity	640 MB (Mode 2, 12 cm)
Block size	2368, 2352 bytes (Mode 0)
	2352, 2340, 2336, 2048 bytes (Mode 1)
	2352, 2340, 2336, 2048 bytes (Mode 2)
Dimensions
Height	12.7 mm (0.50 in)
Depth	132.08 mm (5.20 in)
Width	132.08 mm (5.20 in)
Weight	0.34 kg (0.75 lb)
Data transfer rate
Sustained	150 KB/s (Sustained 1X), 1500/3600 KB/s (10X to 24X)
Burst	16.6 MB/s
Access times (Typical)
Full stroke	300 ms
Random	140 ms
Diameter	12 cm, 8 cm (4.70 in, 3.15 in)
Thickness	1.2 mm (0.05 in)
Track pitch	1.6 m (6.3 10-7 in)
Cache/buffer	128 KB
Startup time	< 10 s
Stop time	< 5 s (Single); < 30 s (Multisession)
Laser parameters
Type	Semiconductor laser GaAs
Wave length	700 25 nm
Divergence angle	53.5 1.5
Output power	0.14 mW
Operating conditions
Temperature	5C to 45C (41F to 118F)
Humidity	5% to 90%

DVD-ROM drive specifications

Specification	Description
Disk formats	DVD (Single and double layer), DVD-5, DVD-9, DVD-10, DVD-R, CD-ROM Mode 1 and 2, CD-DA, CD-XA (Mode 2, form 1 and 2), CD-I (Mode 2, Form 1 and 2), CD-I ready, CD-Bridge, CD-R, PhotoCD (Single and Multi-Session)
Capacity	4.7GB (DVD-5), 8.5GB (DVD-9), 9.4GB (DVD10), 550Mb (Mode 1, 12 cm),640Mb (Mode 2, 12 cm), 180Mb (8 cm)
Block size	2352 bytes (Mode 0)2352, 2340, 2336, 2048 bytes (Mode 1)2352, 2340, 2336, 2048 bytes (Mode 2)2048 bytes (DVD)
Dimensions
Height	12.7 mm (0.50 in)
Depth	132.08 mm (5.20 in)
Width	132.08 mm (5.20 in)
Weight	0.34 kg (0.75 lb)
Data transfer rate
Sustained	4463 - 10,800 KB/s (8X CAV DVD mode), 150 KB/s (Sustained 1X CD-ROM),1552 3600 KB/s (24X CAV CD-ROM)
Burst	16.6 MB/s with DMA support
Access times (typical)
Full stroke	<200 ms CD<300 ms DVD
Random	<110 ms CD<180 ms DVD
Diameter	12 cm, 8 cm (4.70 in, 3.15 in)
Thickness	1.2 mm (0.05 in)
Track pitch	0.74 m (3.15 10-7 in) DVD-ROM1.6 m (6.3 10-7 in) CD-ROM
Cache/buffer	128KB
Startup time	< 10 s
Stop time	< 5 s (Single); < 30 s (Multisession)
Laser parameters
Type	Semiconductor laser GaAs
Wave length	700 25 nm
Divergence angle	53.5 1.5
Output power	0.14 mW
Operating conditions
Temperature	5C to 45C (41F to 118F)
Humidity	5% to 90%

top

Serial Attached SCSI (SAS) hard drive specifications

Item	36GB SAS drive	72GB SAS drive	146GB SAS drive
Capacity	36,420MB	73,408MB	146,815MB
Height	25.4 mm (1.0 in)	25.4 mm (1.0 in)	25.4 mm (1.0 in)
Interface	SAS	SAS	SAS
Transfer rate	3 Gb/s	3 Gb/s	3 Gb/s
Rotational speed	15,000 rpm	15,000 rpm	15,000 rpm
Bytes per sector	512	512	512
Logical blocks	71,132,959	143,374,737	286,749,487
Operating temperature	10 to 35 C (50 to 95 F)	10 to 35 C (50 to 95 F)	10 to 35 C (50 to 95 F)

top

Item	80GB SATA	160GB SATA	250GB SATA	500GB SATA
Capacity	80,026MB	160,041MB	250,059MB	500,107MB
Height	2.611 cm (1.028 in)	2.611 cm (1.028 in)	2.611 cm (1.028 in)	2.611 cm (1.028 in)
Interface	Serial ATA	Serial ATA	Serial ATA	Serial ATA
Transfer rate	1.5 Gb/s	1.5 Gb/s	1.5 Gb/s	1.5 Gb/s
Rotational speed	7,200 rpm	7,200 rpm	7,200 rpm	7,200 rpm
Bytes per sector	512	512	512	512
Logical blocks	156,301,488	312,581,808	488,397,168	976,773,168
Operating temperature	5 to 55 C (41 to 131 F)	5 to 55 C (41 to 131 F)	5 to 55 C (41 to 131 F)	5 to 55 C (41 to 131 F)

Smart Array E200icontroller

Specification	Description
Disk drive and enclosure	3G SAS
Interface	1.5G Serial Advanced Technology Attachment (SATA)
SAS connectors	2 internal (SFF8484) x4 wide port connectors
Cache memory speed	DDR-1/266 MHz provides up to 4.2 GB/s maximum bandwidth
Server interface	x4 2.5G PCIe provides 2 GB/s maximum bandwidth
SAS speed	x8 3G SAS provides 2.4 GB/s maximum bandwidth
Cache memory	40-bit 64MB or 128MB cache: ECC protection, battery-backed, andtransportable
Logical volumessupported	Up to 32 logical volumes
Maximum volumescapacity	3TB (6 x 500GB)
Host memory addressing	64-bit, supporting greater than 4GB server memory space
RAID support	RAID 5 (Distributed data guarding) requires 128MB BBWC option RAID 1, 1+0 (Striping and mirroring) RAID 0 (Striping)
Upgradeable firmware	Upgradeable firmware

Smart Array P400icontroller

Specification	Description
Disk drive and enclosure	3G SAS
Interface	1.5G SATA
SAS connectors	2 internal (SFF8484) x4 wide port connectors
Cache memory speed	DDR2-533 MHz with 40 or 72-bit wide bus provides up to 4.2 GB/smaximum bandwidth
Server interface	x8 2.5G PCIe provides 2 GB/s maximum bandwidth
SAS speed	x8 3G SAS provides 2.4 GB/s maximum bandwidth
Cache memory	40-bit 256MB cache (72-bit 512MB module upgrades available); ECCprotection, Battery-Backed, and transportable
Logical drives supported	Up to 32 logical drives
Maximum logical drivecapacity	3TB (6 x 500GB)
Host memory addressing	64-bit, supporting greater than 4GB server memory space
RAID support	RAID 6 with Advanced Data Guarding (ADG) requires Battery Backed WriteCache (BBWC) upgrade RAID 5 (Distributed data guarding) RAID 1+0 (Striping and mirroring) RAID 0 (Striping)
Upgradeable firmware	Upgradeable firmware with recovery ROM feature

Embedded NC373imultifunction gigabitserver adapters

Specification	Description
Network interface	10/100/1000-T
Compatibility	EEE 802.3 10Base-T IEEE 802.3ab 1000Base-T IEEE 802.3u 100Base-TX
Data transfer method	PCI express, four lanes (x4)
Network transfer rate	10Base-T (Half-Duplex) 10 Mb/s
	10Base-T (Full-Duplex) 20 Mb/s
	100Base-TX (Half-Duplex) 100 Mb/s
	100Base-TX (Full-Duplex) 200 Mb/s
	1000Base-TX (Half andFull-Duplex)
Connector	RJ-45
Cable support	10Base-T	Categories 3, 4 or 5 UTP up to 328 ft (100 m)
Cable support	10/100/1000 Base-TX	Category 5 UTP up to 328 ft (100 m)

top

©Copyright 2025 Hewlett Packard Enterprise Development LP Hewlett Packard Enterprise Development shall not be liable for technical or editorial errors or omissions contained herein. The information provided is provided "as is" without warranty of any kind. To the extent permitted by law, neither HPE nor its affiliates, subcontractors or suppliers will be liable for incidental, special or consequential damages including downtime cost; lost profits; damages relating to the procurement of substitute products or services; or damages for loss of data, or software restoration. The information in this document is subject to change without notice. Hewlett Packard Enterprise Development and the names of Hewlett Packard Enterprise Development products referenced herein are trademarks of Hewlett Packard Enterprise Development in the United States and other countries. Other product and company names mentioned herein may be trademarks of their respective owners.