Help > Getting started > Setting up your network

Setting up your network

The HPE OfficeConnect Solution requires you to connect your HPE OfficeConnect OC20 to the network. HPE OfficeConnect OC20 is a dual-radio, IEEE 802.11ac-capable wireless access point. This access point supports 802.11ac and legacy 802.11a, 802.11b, 802.11g, and 802.11n wireless devices.

To provision your network, follow these steps:

Connect HPE OfficeConnect OC20 to your network.

Verify the LED indicators. If the AP is successfully connected to your provisioning network, the LED indicator turns green.

Table 1: LED Patterns
LED pattern		Conditions
	LED1 – Off LED2 – Off	No power to the AP from either the Power over Ethernet (PoE) or power supply unit (PSU).
	LED1 – Blinking Green LED2 – Off	AP is booting.
	LED 1 – Solid Green LED 2 – Off	AP finished booting, but is not configured yet, and is broadcasting the unconfigured SSID.
	LED1 – Blinking Red LED2 – Off	AP failed to get an IP address from the network.
	LED1 – Solid Red LED2 – Off	Boot failure.
	LED1 – Blinking Green LED2 – Blinking Green (LED1 and LED2 blinking simultaneously)	AP is trying to join a cluster.
	LED1 – Blinking Green LED2 – Blinking Amber (LED1 and LED2 alternate)	AP or cluster is being configured through the initial setup. It also indicates that the AP locator function is on.
	LED1 – Solid Green LED2 – Solid Green	AP joined the cluster and is configured, operational and offering network services.
	LED1 – Solid Green LED2 – Blinking Amber	AP cannot reach the Internet.
	LED1 – Blinking Red LED2 – Blinking Amber (LED1 and LED2 alternate)	AP is not authorized to join the cluster.

If you want to use the mobile app version, download the HPE OfficeConnect Wi-Fi Portal app.

Launch the HPE OfficeConnect Wi-Fi Portal application.

The following figure illustrates the HPE OfficeConnect OC20 provisioning procedure:

Figure 1 HPE OfficeConnect Wi-Fi Portal Provisioning Example

Great! Thanks for the feedback.